china valve

chamgu valve worldwide

首页 关于我们 产品展示 新闻中心 经典应用 人才中心 联系我们 English
  球阀  |  闸阀  |  蝶阀  |  截止阀  |  止回阀  |  减压阀  |  电磁阀  |  调节阀  |  旋塞阀  |  疏水器(阀)  |  过滤器  |  隔膜阀  |  安全阀  |  针型阀 仪表阀  |  放料阀  |  给排水阀门  |  阻火器  |  呼吸阀  |  节流阀  |  底阀  |  角座阀  |  平衡阀  |  排泥阀  |  排气阀  |  切断阀  |  保温阀  |  电站阀门  |  油田阀门  |  气动阀门  |  电动阀门  |  视镜 视盅  |  刀闸阀  |  进口阀门 英国UK优科阀门  |  进口阀门 德国托普TOP阀门  |  阀门技术资料参数  |  进口阀门  |  阀门概述  |  阀门法兰标准  |  阀门选型资料  |  阀门使用说明书  |  进口阀门-美国威盾VTON阀门  |  进口阀门 日本北泽KITZ阀门  |  进口阀门 日本阀天VENN阀门  |  阀门简介  |  阀门厂  |  暖通控制阀  |  阀门
网站地图

|

在线咨询
您现在的位置:北京德泰科阀门有限公司 - 新闻中心 - 行业新闻
止回阀选型所考虑的参数

发布时间:2012-05-22 来源地:

止回阀选型所考虑的参数

止回阀的选型标准内容如下:

1、为了防止介质逆流,在设备、装置和管道上都应安装止回阀;

2止回阀一般适用于清净介质,不宜用于含有固体颗粒和粘度较大的介质;

3、一般在公称通经50mm的水平管道上都应选用立式升降止回阀

4直通式升降止回阀在水平管道和垂直管道上都可安装;

5、对于水泵进口管路,宜选用底阀,底阀一般只安装在泵进口的垂直管道上,并且介质自下而上流动;

6、升降式较旋启式密封性好,流体阻力大,卧式宜装在水平管道上,立式装在垂直管道上;

7、旋启式止回阀的安装位置不受限制,它可装在水平、垂直或倾斜的管线上,如装在垂直管道上,介质流向要由下而上;

8旋启式止回阀不宜制成小口径阀门、可以做成很高的工作压力,PN可达到42MPa,而且DN也可以做到很大,最大可以达到2000mm以上。根据壳体及密封件的材质不同可以适用任何工作介质和任何工作温度范围。介质为水、蒸汽、气体、腐蚀性介质、油品、药品、等。介质工作温度范围在 -196--800之间;适用场合是低压大口径,而且安装场合受到限制;

9蝶式止回阀的安装位置不受限制,可以安装在水平管路上,也可以安装在垂直或倾斜的管线上;

Valve selection criteria as follows: 1, in order to prevent the media counter-current in the device, the device should be installed on the valve and piping; 2, the check valve for clean media generally should not be used to contain solid particles and the viscosity of the medium; 3, generally in the nominal level by 50mm pipe should be selected on the vertical lift check valve; 4, straight-lift valve in horizontal pipe and vertical pipe can be installed; 5, the import pipeline for water pumps, should be selected at the end of the valve, bottom valve is generally installed in the vertical pipe on the pump suction, and the media bottom-up flow; 6, compared with Swing Lift sealing, fluid resistance, horizontal pipe should be installed in horizontal, vertical mounted on the vertical pipe; 7, swing check valve is installed without restriction, it can be installed in horizontal, vertical or inclined pipeline, such as installed in the vertical pipe, the media flow to the bottom up; 8, Swing Check valves should not be made ​​of small diameter, can be made very high work pressure, PN up to 42MPa, and the DN can be large, the maximum can reach more than 2000mm. According to the shell and sealing material can be applied to any work in different media and any operating temperature range. Medium is water, steam, gases, corrosive media, oil, medicines, etc. Medium temperature range of -196 - 800 between; 9, for large-diameter low-pressure situations, and limited installation of occasions; 10, the butterfly valve is installed without restrictions, can be installed in a horizontal tube on the road can also be installed in vertical or inclined pipeline;

 



【声明】:
  以上文章或资料除注明为北京德泰科阀门有限公司自创或编辑整理外,均为各方收集或网友推荐所得。其中摘录的内容以共享、研究为目的,不存在任何商业考虑。
  目前网站上有些文章未注明作者或出处,甚至标注错误,此类情况出现并非不尊重作者及出处网站,而是因为有些资料来源的不规范。如果有了解作者或出处的原作者或网友,请告知,本网站将立即更正注明,并向作者道歉。
  被摘录的对象如有任何异议,请与本站联系,联系邮箱:lcz@valve.cnkitz.com,本站确认后将立即撤下。谢谢您的支持与理解!
 
新闻中心
   公司新闻
   行业动态
产品系列
闸阀 止回阀
蝶阀 球阀
截止阀 调节阀
水力控制阀 减压阀
气动头 特殊阀

Copyright 2006 北京德泰科阀门有限公司 All Rights Reserved.京ICP备10035313号 阀门 进口阀门 北京阀门厂 阀门公司
地址:北京市大兴工业开发区 电话:010-57039662(3线)010-59430603 手机:15910656008 13693323008 传真:010-60129533
友情链接:阀门 阀门厂 阀门网 阀门公司